The good news is that these inverter cables are interchangeable, so it doesn’t matter which of the two you plug into the connectors on both the top and bottom. Start by placing the display unit back on, making sure to rest the right edge on the iMac as you prop up the left side, since you’ll need to plug the inverter cables back in. Luckily, reassembling it is the same as taking it apart, but in reverse. Now that the SSD is in place and ready to go, it’s time to put everything back together. There are no moving parts and even without the adapter bracket, it will still stay snug inside once the iMac is reassembled. However, what you can do is simply get rid of the adapter and connect just the SSD, leaving it hanging freely. Lock it in place with the locking tab, making sure that it clicks into place.ĭepending how the adapter mounts your SSD, the SATA cables may not be able to reach, which means you’re stuck.

Next, insert the pins into their respective ports on the iMac and then drop the rest of the SSD in. Do this very slowly and carefully, as there is a cable you’ll need to disconnect! This will loosen the bezel and you can begin to work your way down until the whole bezel lifts up. Place your thumb on the edge of the display and your fingers on the back side of the iMac. From there, push your thumb down as your pull up your fingers. The best way to do this is by starting in the upper corners. Be aware that the four screws along the bottom are longer than the rest, so make sure you put all of them back in the correct locations.Īfter you remove these screws, it’s time to remove the whole front bezel. Next, there are twelve T8 Torx screws around the edge of the display that need removed. If you’re worried about scratching it, place it on a soft surface away from the work area. The glass is simply held on by magnets, so all you have to do is lift straight up and the glass panel will come right off. Next, take your suction cups and place them in opposite corners of the screen.

Internal hard drive for imac 2007